SCANNY
1.1.0 beta 9
1.1.0 beta 9SHOWDATE04 OCT 2026CHANGES05BETA
COPY, PUT BACK and UNDO BATCH show a camera an RCP holds before you press Apply, with a TAKE OVER button on its line (and TAKE OVER ALL when two or more are held). A held camera is never a silent failure. Taking over a value the RCP just moved goes in 2 presses.
SAFETY 01
LOCK EVERYTHING clears every half-done take-over
A first press made before LOCK EVERYTHING never finishes a take-over after it, on an ALEXA or an FR7. On an FR7, if another RCP or the CNS bridge takes the camera between the two presses, the second press starts again and names who has it now.
IMPROVED 02
COPY, PUT BACK and UNDO BATCH: take over before Apply
A camera an RCP holds now says so on its line before you press Apply: held by RCP-01, with a small TAKE OVER button at the end. One click takes that camera over for this session (logged in Activity). With two or more held, TAKE OVER ALL sits next to Apply: one click, each camera logged. It takes only the cameras Apply will write: an unticked camera, or an on-air one without ALLOW ON AIR, keeps its RCP. Then Apply sends through every usual check.
Take over a value the RCP just moved: 2 presses, not 3
When the only reason to ask AGAIN? is that the RCP just moved that value, the press that takes over also answers it. EI on a held, off-air camera now goes in 2 presses. Off air only: on air (LIVE fine steps too), first use on a camera in PVW, or any other reason still asks.
FIXED 02
A held camera in a COPY is skipped with the reason
If a camera is still held when Apply runs, its line reads SKIPPED · HELD BY RCP-01 and nothing is sent to it; the other cameras go on. Before, each held camera failed setting by setting with Held by RCP — nothing sent.
Take-over words leave when the hold does
Unlock with the orange chip during the 3 s after a first press and RCP-01 HAS IT · AGAIN TO TAKE OVER leaves the control at once.